1 Remove old grout and mask off
Scrape out the grout from around the cracked tile. To protect surrounding tiles, use tape to 'mask' them off. Place some tape in the centre of the tile to stop the drill bit slipping and drill two or three holes in the centre of the tile.
2 Chip out the tile
Use a fine cold chisel - or an old woodworking chisel - and a club hammer to cut away the tile. Work from the centre of the tile outwards so you don't damage or dislodge the neighbouring tiles.
3 Chisel out the old adhesive
In order for the new tile to lie flush and stick to the wall securely, chisel out all of the old adhesive. Brush away the debris - if possible, vacuum it out as any dust or debris will impair adhesion.
4 Position the new tile
'Butter' the back of the replacement tile with adhesive and press it into place. Leave to dry and then renew the grout around it.
Useful Tips - Drilling Tiles
- Use a masonry bit at a slow speed when you drill through the tile.
- To stop the tip of the bit from slipping, place tape on the tile face.
- Don't use a hammer action to drill or you'll shatter the tile and may even damage the surrounding ones as well.
- Don't drill too deeply into the wall, and remember to watch out for hidden water pipes.
Previous
